Oki C9600hdn Network And Configuration Manual page 54

Reset
Resets the selected network interface card.
Test Print
Prints the self-diagnostic test pages (see page 12).
IP Address Setup
Sets the static IP address of the network interface card manually.
If you only use TCP/IP and the print server has not yet been
configured, occasionally it may not be displayed on
AdminManager. You can configure the IP address of the print
server by this function.
1. Enter the [Ethernet Address] (MAC Address) and the [IP
Address], then click [OK].
The Ethernet (MAC) Address is displayed under
"General Information" on the self-diagnostic test
printout (see page 12).
2. AdminManager asks whether you want to initialize the network
interface card or not. Select [Yes].
Even if you select [No] here, the IP address that you
set can be used after turning the printer OFF and ON.
The requirement to turn your printer OFF and ON is
dependent on the network interface card.
Configuration: Using AdminManager Standard Setup • 54
NOTE
NOTE