HP XP P9500 Configuration Manual page 57

Example 9 Configuration file example – UNIX-based servers
HORCM_MON
#ip_address service
HST1 horcm
HORCM_CMD
#unitID 0... (seq#30014)
#dev_name dev_name
/dev/rdsk/c0t0d0
#unitID 1... (seq#30015)
#dev_name dev_name
/dev/rdsk/c1t0d0
HORCM_DEV
#dev_group dev_name
oradb oradb1
oradb oradb2
oralog oralog1
oralog oralog2
oralog oralog3
oralog oralog4
HORCM_INST
#dev_group ip_address
oradb HST2
oradb HST3
oralog HST3
Figure 12 Configuration file example – Windows servers
The configuration file sets the following parameters:
(1) HORCM_MON
The monitor parameter (HORCM_MON) defines the following values:
Ip_address: The network address (IPv4 or IPv6) of the local host. When HORCM has two or
more network addresses on different subnets or MPE/iX, enter NONE for IPv4 or NONE6 for
IPv6 here.
Service: Specifies the UDP port name assigned to the HORCM communication path, which is
registered in "/etc/services" ("\WINNT\system32\drivers\etc\services" in Windows,
"SYS$SYSROOT:[000000.TCPIP$ETC]SERVICES.DAT" in OpenVMS). If a port number is
specified instead of a port name, the port number is used.
poll(10ms) timeout(10ms)
1000 3000
dev_name
dev_name
port# TargetID
CL1-A 3
CL1-A 3
CL1-A 5
CL1-A1 5
CL1-A1 5
CL1-A1 5
service
horcm
horcm
horcm
LU# MU#
1 0
1 1
0
0
1
1 h1
Sample configuration definition files 57