5 Solaris (x86 and SPARC)
Overview
This chapter describes how to configure the HP StoreOnce Backup System for use with the following
Solaris operating systems:
Solaris 9 (SPARC)
Solaris 10 (x86 and SPARC)
NOTE:
HP StoreOnce Backup Systems with iSCSI interfaces are only supported with Solaris 10u4
or greater.
Configuring the HP StoreOnce Backup System for iSCSI
If your product supports iSCSI use the information in this section to configure it.
If your product does not support iSCSI, go to
Channel (page
How to enable the iSCSI software initiator
1.
Enable the iSCSI services using the command:
# svcadm
svc:/network/iscsi_initiator:default enabled
2.
Verify the iSCSI services are running:
# svcs
Online
How to configure the iSCSI software initiator using the D2Dsetup script
Use the D2Dsetup script to configure the iSCSI software initiator automatically. You must provide
the IP address as a parameter to the script.
# D2Dsetup <IP_address>
If you wish to configure CHAP authentication, you should also provide the user name and password
for the initiator and the target, if required.
# D2Dsetup <Initiator_CHAP_Username> <Initiator_CHAP_Password>
<Target_CHAP_Username> <Target_CHAP_Password> <IP_address>
The response from the HP StoreOnce Backup System will be similar to the following:
HP StoreOnce Backup System Linux and UNIX iSCSI Configuration Tool
Detecting OS...................................done
Checking iSCSI package.........................done
Contacting HP StoreOnce Backup System...done
Discovering available targets..................done
Configuring persistant logins..................done
Configuring drivers............................done
Configuring CHAP authentication................done
The following library devices are configured:
Target: iqn.1986-03.com.hp:storage.d2d.cr2070143b.500110a125810bbf.library1
.robotics
Alias: D2D.CR2070143B.Library1.Robotics
TPGT: 1
ISID: 4000002a0000
Connections: 1
LUN: 0
Vendor:
Product: 1x8 G2 AUTOLDR
OS Device Name:
Target: iqn.1986-03.com.hp:storage.d2d.cr2070143b.500110a250017b86.library1.drive
Alias: D2D.CR2070143B.Library1.Drive1
30).
v enable iscsi_initiator
a | grep iscsi_initiator
10:10:28 svc: /network/iscsi_initiator:default
HP
Configuring the HP Backup System for Fibre
Overview
27