Displaying The Uptime For A Switch - Brocade Communications Systems StoreFabric SN6500B Troubleshooting Manual

10
The switchShow command also displays the following information for ports on the specified switch:
TABLE 17
Variable
Index
Slot
Port
Address
Media
Speed
State
Proto
The details displayed for each switch differ on different switch models. For more information see
the switchShow command in the Fabric OS Command Reference.
To display the switch information, perform the following task.
1. Connect to the switch and log in as admin.
2. Enter the switchShow command.

Displaying the uptime for a switch

1. Connect to the switch and log in as admin.
2. Enter the uptime command:
86
Switch status
switchShow command output
Definition
Index follows Area up to 255. Then it continues
to the maximum port of the platform. Index
identifies the port number relative to the
switch. Index column is only displayed on
enterprise-class platforms.
Slot number 1–4 and 7–10.
Port number 0–15, 0–31, or 0–47.
The 24-bit Address Identifier. Address column
is only displayed on enterprise-class platforms.
SFP types used.
The speed of the Port (1G, 2G, 4G, 8G, 10G,
N1, N2, N4, N8, AN, UN). The speed can be
fixed, negotiated, or auto-negotiated.
The port status.
Protocol support by GbE port.
ecp:admin> uptime
10:50:19 up 11 days,
The uptime command displays the length of time the system has been in operation, the total
cumulative amount of uptime since the system was first powered on, and the load average
over the past one minute (1.29 in the preceding example), five minutes (1.31 in the example),
and 15 minutes (1.27 in the example). The reason for the last switch reboot is also recorded in
the system message log.
6:28, 1 user, load average: 0.49, 0.53, 0.54
Fabric OS Troubleshooting and Diagnostics Guide
53-1002751-01