Brocade Communications Systems StoreFabric SN6500B Troubleshooting Manual page 110

10
FIGURE 5
For configuration details see
Topology 3: Access Gateways
Figure 6
and F represent, respectively, an N_Port and an F_Port to be configured as D_Ports. (See note
below.) The following equipment is supported, in any mix-or-match combination:
•
•
FIGURE 6
Figure 7
F represent, respectively, an N_Port and an F_Port to be configured as D_Ports. (See note below.)
There is no D_Port support for HBA connectivity to the Access Gateway. The following equipment is
supported, in any mix-or-match combination:
•
•
FIGURE 7
For configuration details see
NOTE
You cannot configure a D_Port in the above topologies if N_Port-to-F_Port mappings are already
present on the Access Gateway.
94
Diagnostic Port (D_Port)
ICLs connecting chassis blades
"Using D_Port without HBAs"
illustrates a switch configured as a single Access Gateway connected to a fabric switch. N
Access Gateways: Brocade 6505, 6510
Switches: Brocade DCX 8510-4, DCX 8510-8, 6505, 6510, 6520
Single Access Gateway to switch
illustrates multiple Access Gateways connected to a switch in a cascaded topology. N and
Access Gateways: Brocade 6505, 6510
Switches: Brocade DCX 8510-4, DCX 8510-8, 6505, 6510, 6520
Multiple Access Gateways cascaded to switch
"Using D_Port without HBAs"
See"Saving port mappings on an Access Gateway"
Fabric OS Troubleshooting and Diagnostics Guide
on page 95.
on page 95.
on page 97.
53-1002751-01