Downloading A Correct Configuration; Reconciling A Domain Id Conflict - Brocade Communications Systems StoreFabric SN6500B Troubleshooting Manual

3
Alternatively, you can reconcile fabric parameters by entering the configUpload command for each
switch and upload a known-good configuration file. If you do this option, the two switches must be
the same model.

Downloading a correct configuration

You can restore a segmented fabric by downloading a previously saved correct backup
configuration to the switch. Downloading in this manner reconciles any discrepancy in the fabric
parameters and allows the segmented switch to rejoin the main fabric. For details on uploading
and downloading configurations, refer to the Fabric OS Administrator's Guide.

Reconciling a domain ID conflict

If a domain ID conflict appears, the conflict is only reported at the point where the two fabrics are
physically connected. However, there may be several conflicting domain IDs, which appear as soon
as the initial conflict is resolved.
Typically, the fabric automatically resolves domain conflicts during fabric merges or builds unless
Insistent Domain ID (IDID) is configured. If IDID is enabled, switches that cannot be programmed
with a unique domain ID are segmented out. Check each switch that has IDID configured and make
sure their domain IDs are unique within the configuration.
Repeat the following procedure until all domain ID conflicts are resolved.
1. Enter the fabricShow command on a switch from one of the fabrics.
2. In a separate Telnet window, enter the fabricShow command on a switch from the second
3. Compare the fabricShow output from the two fabrics. Note the number of domain ID conflicts;
4. Choose the fabric on which to change the duplicate domain ID; connect to the conflicting
5. Enter the switchDisable command.
6. Enter the configure command.
7.
8. When the Domain prompt displays, type in the new number.
9. Press enter on all prompts to accept their default settings.
10. Enter the switchEnable command.
11. Repeat
Example of setting the domain ID
38
Segmented fabrics
fabric.
there may be several duplicate domain IDs that must be changed. Determine which switches
have domain overlap and change the domain IDs for each of those switches.
switch in that fabric.
When the Fabric Parameters prompt displays, type y.
This enables the joining switch to obtain a new domain ID as part of the process of coming
online. The fabric principal switch allocates the next available domain ID to the new switch
during this process.
step 4 through step 10
switch_89:FID89:admin> switchdisable
switch_89:FID89:admin> configure
Configure...
if additional switches have conflicting domain IDs.
Fabric OS Troubleshooting and Diagnostics Guide
53-1002751-01