Table of Contents
Advertisement
Front Fan Bracket
To remove the front fan bracket:
1. Power down the device. See the "Powering Down the Device" section in this chapter.
2. Extend or remove the device from the rack. See the "Preparation Procedures" section in
this chapter.
3. Remove the access panel. See the "Access Panel" section in this chapter.
4. Remove all the hot-plug fans in the bracket. See the "Hot-Plug Fan" section in this
chapter.
5. Press inward on the release levers.
6. Lift the bracket.
Figure 2-27: Removing the front fan bracket
IMPORTANT: Tighten the system board thumbscrew before installing the front fan
bracket. The fan bracket does not seat securely if the thumbscrew is not fully tightened.
Reverse steps 1 through 6 to replace the front fan bracket.
NAS B2000 Maintenance and Service Guide
2
1
Removal and Replacement Procedures
1
2-29
Advertisement
Table of Contents
