Table of Contents
Advertisement
Removal and Replacement Procedures
Smart Array 5i Controller
To remove the Smart Array 5i Controller:
1. Power down the device. See the "Powering Down the Device" section in this chapter.
2. Extend or remove the device from the rack. See the "Preparation Procedures" section in
this chapter.
3. Remove the access panel. See the "Access Panel" section in this chapter.
4. Remove the PCI riser cage. See the "PCI Riser Cage" section in this chapter.
5. Turn each of the four anchor pins counterclockwise one-quarter turn.
6. Lift the controller off the system board.
Figure 2-49: Removing the Smart Array 5i Controller
IMPORTANT: In the default position (off), the SCSI interlock disable switch prevents
the StorageWorks by Compaq NAS B2000 from booting when the Smart Array 5i
Controller is removed. If you operate the device without the Smart Array 5i Controller for
troubleshooting purposes, you must set the SCSI interlock disable switch to on. For
more information, see Chapter 4, "Connectors, LED Indicators, Switches, and
Jumpers."
Reverse steps 1 through 6 to replace the Smart Array 5i Controller.
2-50
2
1
NAS B2000 Maintenance and Service Guide
Advertisement
Table of Contents
