Table of Contents
Advertisement
PCI Riser Cage
CAUTION: To avoid the risk of damage to your system or expansion boards,
remove all AC power cords before installing or removing non-hot-plug
expansion boards. Moving the Power On/Standby button to the standby
position still provides auxiliary power to the PCI expansion slot and may
damage the board or other system components.
To remove the PCI riser cage:
1. Power down the device. See the "Powering Down the Device" section in this chapter.
2. Disconnect any external cables connected to expansion boards.
3. Extend or remove the device from the rack. See the "Preparation Procedures" section in
this chapter.
4. Remove the access panel. See the "Access Panel" section in this chapter.
5. Disconnect the long SCSI cable from any array controller PCI expansion board, if
installed.
6. Pull up the thumbscrew knobs.
7. Loosen both thumbscrews by turning them counterclockwise.
Figure 2-29: Loosening the PCI riser cage thumbscrews
NAS B2000 Maintenance and Service Guide
1
2
Removal and Replacement Procedures
1
2
2-31
Advertisement
Table of Contents
