Table of Contents
Advertisement
Diskette Drive
To remove a diskette drive:
1. Power down the device. See the "Powering Down the Device" section in this chapter.
2. Extend or remove the device from the rack. See the "Preparation Procedures" section in
this chapter.
3. Remove the access panel. See the "Access Panel" section in this chapter.
4. Disconnect the diskette interface cable from the SCSI backplane.
5. Loosen the diskette drive thumbscrew.
6. Slide the diskette drive toward the SCSI backplane and lift.
Figure 2-23: Removing the diskette drive
Reverse steps 1 through 6 to replace the diskette drive.
NAS B2000 Maintenance and Service Guide
3
1
2
Removal and Replacement Procedures
2-25
Advertisement
Table of Contents
