Table of Contents
Advertisement
Power Button/LED Cable
To remove the power button/LED cable:
1. Power down the device. See the "Powering Down the Device" section in this chapter.
2. Extend or remove the device from the rack. See the "Preparation Procedures" section in
this chapter.
3. Remove the access panel. See the "Access Panel" section in this chapter.
4. Disconnect the power button/LED cable from the SCSI backplane.
5. Disconnect the power button/LED cable from the power button/LED board.
Figure 2-57: Removing the power button/LED cable
Reverse steps 1 through 5 to replace the power button/LED cable.
NAS B2000 Maintenance and Service Guide
2
1
Removal and Replacement Procedures
2-59
Advertisement
Table of Contents
