GeForce 8100/8200/8300-ITX series Motherboard
Jumper Setting
This chapter explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this
chapter whenever in doubt.
JH-CMOS Clear
JH
1-2*
2-3
JPUSB-Rear USB Power Selection
JPUSB
1-2*
2-3
Close Open * Default setting.
Notice:
1.
Be sure to save the CMOS setting when exit the CMOS.
2.
If the CPU is frequency multiplier locked, no CPU speed change will be seen
even if the frequency multiplier setting in CMOS setup is changed.
8
Selection
Normal*
CMOS Clear
Selection
5V power input
5V standby power input