Installing The Battery - HP Photosmart R707 User Manual

_nstaHing the Battery
Yourcameracan useeithera rechargeabbHPPhotosmart R 07
lithium ion battery(L1812A) or a disposableDuracelk_CP1
battery.
NOTE If a rechargeabb battery was shipped with your
camera, it will be partially charged, but you should fully
charge it before using it the first time. You can charge the
battery while it is in the camera. SeeCharging _'heBaffery
on page 16.
If the Battery/Memory card door is already open, skip this
step and go on to step 2.
Hold the camera with the bottom
facing up, and the front of the
camera facing you. Then slide the
Battery/Memory card door on the
bottom of the camera away from
you, toward the back of the
camera.
2 Insert the battery in the larger slot
as shown, and push it in until the
latch catches.
3 Close the Battery/Memory card
door by pushing the door down
and then sliding the door toward
the front of the camera until the
door latches.
To remove the battery from the camera, first turn the camera
off. Then open the Battery/Memory card door, release the
battery latch, tilt the camera, and the battery will slide out of its
slot.
14 HP Photosmart R707 User's Manual