Wegener UNITY 4600 User Manual page 53

Table 3.3: Command Directory for U4600 Terminal Commands
SP program
program: Either an integer between
(representing a name), preference being on a number to resolve ambiguity.
Command changes selected
works similarly to a PERM command.
TEMP [format] [feed #] [carrier freq] [data rate] [FEC] [Tag Site] program# time
For format, feed #, carrier freq, data rate, FEC, tag site, and program #, see
time: Length of insert in either
OK to omit on hours) OR in number of seconds. (A one-hour
parameters: of
Command which performs a volatile temporary insert for an amount of time given by time. Unit sets its
temporary Unit Settings to the values given.
Note:No label may be applied using this terminal command.
TEMPCH value time
value: Either the value of a Preset table entry number OR the Channel Label of an entry, priority
given to Label if any ambiguity. If an entry number, legal values range from
is number of Preset support this product).
N
time: Same as for
Volatile command which sets volatile temporary Unit Settings to those retrieved from the Preset table
according to value for time given by time. Similar to TEMP command.
TEMPSENS
Command displays internal unit temperature if available.
TEST group value
group: Mnemonic for a test group: Either
value: Parametric value which has meaning depending on the test group selected.
Command to activate Installation Test Modes. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
If group is , the legal values are
RF
the RF level (not locked to carrier) at that RF Feed Port every few seconds. Entering
measurement.
If group is , the legal values are
AV
test tones activated on the audio output, the same as the generic
If group is , the legal values are
DTMF
command entered with no parameters
If group is , the legal values are
REL
and de-energized.
TESTOFF
Command stops all volatile test functions as if unit were reset. A Local Control Command (available from
the terminal regardless of "Local Control Enable/Disable" commands from the network).
www.wegener.com
and
1 65,535
by Program Number (from PAT) or SDT descriptor. This command
program
format (valid range is
HH:MM:SS
or .)
1:00:00 3600
.
TEMP
RF
, , , , and
1 2 3 4 OFF
and . If
ON OFF ON
and
ON OFF.
and . If
ON OFF
45
U
(representing a number) or an alphanumeric string
0:00:00
TEMP
, , , or .
AV DTMF REL
. Entering numbers for value cause the IRD to report
, a test pattern is activated on the video output and
TESTMODE
If , the command behaves like the
ON
, both user cue relays are alternately energized
ON
4600 U ' M
NITY SER S ANUAL
command.
PERM
to , leading zeros
18:00:00
could have a
up to (where
1 N
stops the
OFF
command.
DTMFVOL
800032-01 Rev.F