Wegener UNITY 4600 User Manual page 43

Table 3.3: Command Directory for U4600 Terminal Commands
H [command]
command: Any of the terminal command names (PC, R, PORT, etc.).
If an or any invalid command beginning with an
H
screen will be displayed, consisting of a list of all currently available commands and a brief description of
each listing. If an
H
Command Name, then detailed help for
the terminal regardless of "Local Control Enable/Disable" commands from the network).
INDPERS indication time
indication: or Alarm or
A
time: Time in seconds.
Command to set the minimum indication-time persistence for either Alarms or Warnings, per the value of
indication, for the time period given by time. Entering command without parameters shows the current
settings. A Local Control Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
IPCONFIG
Command requests report of all current IP parameters (IP address, Gateway address, subnet mask) and
assignment mode (static or DHCP). A Local Control Command (available from the terminal regardless of
"Local Control Enable/Disable" commands from the network).
LAN GATEWAY addr
addr: IP address formatted as
Command sets the IRD's static internet Gateway IP address. No protection is offered against entry of non-
standard addresses (e.g. 0:0:0:0). Omitting the addr parameter shows the current static Gateway IP. This
will not be the current Gateway IP address if dynamically assigned. Use the
A Local Control Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
LAN IP addr
addr: IP address formatted as
Command sets the IRD's static IP address. No protection is offered against entry of non-standard addres-
ses (e.g., 0:0:0:0). Omitting the
address if dynamically assigned. Usethe
(available from the terminal regardless of "Local Control Enable/Disable" commands from the network).
www.wegener.com
or any invalid command beginning with an
command
for Warning.
W
n1:n2:n3:n4
n1:n2:n3:n4
parameter shows the current static IP. This will not be the current IP
addr
IPCONFIG
is entered and
H command
is entered and
H
is displayed. A Local Control Command (available from
where , , , and
n1 n2 n3 n4
where , , , and
n1 n2 n3 n4
command for that. A Local Control Command
35
U 4600 U ' M
NITY SER S
is omitted, the whole help
is a valid User
command
are integers between and
0
command for that.
IPCONFIG
are integers between and
0
800032-01 Rev.F
ANUAL
.
255
.
255