Wegener UNITY 4600 User Manual page 42

U 4600 U ' M
NITY SER S ANUAL
Table 3.3: Command Directory for U4600 Terminal Commands
DTMFVOL percent
percent: Integer between
Command to set DTMF output tone levels. Immediately after entry of the command, the IRD will play out
all 16 tones (at a rate where they are individually identifiable) at the commanded level. If percent is '0',
output is essentially OFF. If percent is '100', level is maximum spec level. Entering command without
parameters still plays out the tone sequence and then reports current level setting. A Local Control
Command (available from the terminal regardless of "Local Control Enable/Disable" commands from the
network).
EMAIL x
x: Either
Command to enable COMPEL printed email. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
ERRORS type threshold
type: Either
threshold: Integer between
Command to set either Error'd-seconds-rate or Continuity-count Alarm threshold. Unit will show an alarm
if, over any previous 60 second interval, the number of type events which are detected exceeds threshold.
A Local Control Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
EXIT
Command ends telnet sessions. Same as
FORCERF port
port: Either
Command to either disable or enable effective RF switch bypassing. If port is a number, then all
subsequent carrier reception is sought at that RF feed port, regardless of the current Unit Setting. If port
is , then normal RF switch function is restored. Entering the command without parameters gives
OFF
current status, either
Control Command (available from the terminal regardless of "Local Control Enable/Disable" commands
from the network).
GHOSTLIST action PID
action:
A
PID: Hex number between
Command to add or delete entries in the list of ghost PIDs to pass to the ASI transport output (while
Program Mapping is enabled). Entering command without the action or pid parameter dumps the current
list.
800032-01 Rev. F
and
0 100
for Enabled, or for Disabled.
E D
for Error'd Seconds or
E
and
1 255
QUIT
or the numbers
OFF
, or
Normal RF Switch
for Add or for Delete.
D
and
1
inclusive.
for Continuity-count errors.
C
.
command.
, , , or .
1 2 3 4
where n is either
Forced RF Feed Port n
(except , reserved for
1FFE 11
34
, , , or . A Local
1 2 3 4
).
SDT
www.wegner.com