Wegener UNITY 4600 User Manual page 48

U 4600 U ' M
NITY SER S ANUAL
Table 3.3: Command Directory for U4600 Terminal Commands
R type [page] (Continued)
[page]: This option can have a value of
Indicates the page to be reported. If omitted, all eight pages are reported and scrolls off
the terminal screen.
With the R command, the user gets a combined report of unit non-volatile settings and status and
diagnostics for each item grouping (e.g., RF for all unit settings and all status diagnostics for carrier
acq/tracking). A Local Control Command (available from the terminal regardless of "Local Control
Enable/Disable" commands from the network).
RD group
group: Indicates group of status/diagnostic information to report, as follows:
AUD
AW
CA
DPI
GL
LAN
NTW
PRGMP
MSC
REC
RF
RPA
SW
TS
VID
Expanded report on unit volatile diagnostic and status information. A Local Control Command (available
from the terminal regardless of "Local Control Enable/Disable" commands from the network).
RE state [number]
state:
ON
number:
1
affected user relay.
This non-volatile command sets the user (or expansion) relay addressed by number to the
"Follow-Warn" (if '
W
Note: The value for the state parameter is only accepted for the native relays (
W
If state is specified, but number is omitted, then the command is applied to ALL installed relays, with one
exception. The exception is that the command to ALL relays will not be accepted by a native user cue
relay already set in the logical "Follow-warn" state. (It MUST be individually addressed to return it to the
or non-volatile state. Entering this command without parameters shows the state of installed
ON OFF
relays.
800032-01 Rev. F
- Audio service diagnos.
- Alarm/Warning status
- Conditional Access diagnostics
- Conditional Digital Program Insertion (DPI)
- Genlock system (if installed and applicable)
- IP/Ethernet diagnostics
- COMPEL network control diagnostics
- Program mapping at ASI output
- Miscellaneous diagnostics
- Automated Recovery status
- Carrier Acquisition/Tracking diagnostics
- Return Path diagnostics
- Software download/self-test status
- Transport Stream diagnostics
- Video service diagnostics
, , or
OFF W
or , or thru n (for n-relay expansion option module, if installed) indicating the
2 E1 E
) state specified.
to 40 and is only applicable for the group status report.
1
40
or
ON/OFF
or ).
1 2
www.wegner.com