Wegener UNITY 4600 User Manual page 50

U 4600 U ' M
NITY SER S ANUAL
Table 3.3: Command Directory for U4600 Terminal Commands
RPATH TO username@addr
username: Legal string of keyboard characters without white space.
addr: IP address formatted as
and
Email address destination for Return Path reporting. A Local Control Command (available from the
terminal regardless of "Local Control Enable/Disable" commands from the network).
SAVENV
Saves all the current global and Unit Setting NV parameters (in NVRAM) to the Flash memory space
designated as
BACKUP
Note: Some unit-set parameters, which would not make sense to "back up", may not be saved.
A Local Control Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
SAVEP [entry#] [channel_label]
entry#: A Preset Table Entry number or the text,
number between
channel_label: Channel Label associated with a unit setting or a Preset Table entry. If attempting to
supply the
be a string of continuous non-white-space keyboard characters. Unit will truncate user
input to 10 characters.
Command saves current Unit Settings to a Preset Table entry, or if
Setting is loaded into the unit's Permanent unit setting. Those metadata fields in the extended Preset
Entry that have no analog in the current Unit setting will be populated with spec defaults. User must use
command to set those fields.
ADDE
If entry# is supplied alone, current unit settings are written to that entry, overwriting existing data if it had
been in use. If channel_label is supplied alone, and if that same Label already appears at a used Preset
Table entry, then the current unit settings overwrite that old Preset data. If channel_label is supplied
alone and no used Preset has that Label, then the current settings are written to the lowest empty Preset
Table entry and then given that same Label. If both entry# and channel_label parameters are supplied,
then the current unit settings are written at that Entry (overwriting existing data if any) and that entry is
supplied that same Label (equal to channel_label).
SERVICE video_pid [pcr_pid] [audio1_pid] [audio2_pid]
video_pid: Hex value between
audio1_pid: Hex value between
audio2_pid: Hex value between
pcr_pid: Hex value between
Command selects A/V services directly by PID number only. This changes Unit Setting #11 to "By PID" if
not already set that way.
800032-01 Rev. F
n1:n2:n3:n4
.
255
.
and inclusive, where
1 N
parameter alone, a value of
channel_label
and
20 1FFE
and
20 1FFE
and
20 1FFE
and
20 1FFE
where n , , , and
n1 n2 n3
. If a preset entry, must be equal to a
PERM
is the highest entry number.
N
PERM
entry#
.
.
.
.
42
are integers between
n4
is not legal. Parameter must
is , a current Transient
PERM
www.wegner.com
0