Wegener UNITY 4600 User Manual page 45

Table 3.3: Command Directory for U4600 Terminal Commands
LOADNV source
source: for Backup (by user),
B
settings. Key security parameters (e.g., serial number) are not affected by the
Command reloads NVRAM memory from Flash memory defaults.
Note: The unit must reset after execution of this command.
MARGIN margin_offset
margin_offset: Integer values between
is defined by individual IRD specifications for every modulation/FEC combination.
Command sets the Margin Warning point. This provides warning to local users that their Eb/No's are
approaching the error-threshold where system performance will collapse. (Supersedes SNR command.)
A Local Control Command (available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
MOVEP source destination
source: Preset Table entry number which will source Unit settings.
destination: Preset Table entry number to which the Unit settings will be moved.
Command moves the Unit settings at the
original entry is deleted and that entry position is now considered unused. The setting data at the
source
original
destination
available because the entry that held the original
MUTE [source][source][source] [...]
source: Source can be any of the following:
ASI
V
A[specifier] - to indicate Audio.
An without the specifier indicates all audio outputs.
A
If present, The specifier consists of one or two characters. The first character specifies the
audio port number and the second character specifies either the right or left channel, as in
(audio 1, left channel) or
A1L
If the second character is omitted, this indicates both stereo channels are included.
Example:
MUTE V A1L A4 A3R
and audio port 3 right channel
Note: If no
source
Mutes the specified outputs.
Note: The command is only allowed when local control is enabled by the network..
MUTE
OH
On hook. Disables modem access. Modem access is only re-enabled by successful modem password
entry. A Local Control Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
www.wegener.com
for Original Customer-configuration, or
C
and
0
source
entry is then moved to the next lower unused Preset position. (One will always be
- to indicate the DVB-ASI transport output.
- to indicate Video.
A2R
mutes the video, audio Port 1 left channel, audio port 4 (both channels),
is specified then video and all audios are selected.
in the form of x.x, representing dB (to tenths of a dB).
N
entry to the
destination
settings was made "unused".)
source
(audio 2, right channel).
37
U 4600 U ' M
NITY SER S
for Production-default
P
or
C P
entry. The setting data at the
800032-01 Rev.F
ANUAL
loads.
N