Wegener UNITY 4600 User Manual page 44

U 4600 U ' M
NITY SER S ANUAL
Table 3.3: Command Directory for U4600 Terminal Commands
LAN MODE mode
mode:
DHCP
Command sets the IP configuration to either dynamic DHCP, "Wegener" mode, or static IP addresses. If
static, see ,
LAN IP
the current mode. This is a Local Control Command (available from the terminal regardless of "Local
Control Enable/Disable" commands from the network).
Assigning "Wegener" mode IP address forces the assignment of a static IP address for testing. This
address is of the form: 172.16.xy.yy. The x is the one- or two-decimal-digit Product ID (also called the
COMPEL download ID). 'yyy' are the last (least significant) digits of the unit serial number (most
significant to left). The presumed subnet mask is 255.255.0.0 but the gateway is not defined. As an
example, if a
Unity 4600
static IP address becomes 172.16.90.50.
To fix possible address contention, the IRD, when the application initializes, attempts to detect an IP
address conflict (using ARP). If a conflict is detected, the unit adds one hundred (decimal) to the last field
of the attempted IP address and tries again. Using the above example, if 172.16.90.50 has already been
assigned on that LAN, then the IRD re-attempts with an IP address equal to 172.16.90.150.
LAN SUBNET addr
addr: IP address formatted as
255
Command sets the IRD's static subnet mask address. Command entries that do not assert legal IP
address masks will be rejected. Omitting the
will not be the current subnet mask if dynamically assigned. Use IPCONFIG command for that. A Local
Control Command (available from the terminal regardless of "Local Control Enable/Disable" commands
from the network).
LATCHALARMS x
x: Either
Command enables or disables the latching of unit alarms.
LNBPWR output
output: Either
Non-volatile command enables or disables LNB DC power independently of any other settings. A Local
Control Command (available from the terminal regardless of "Local Control Enable/Disable" commands
from the network).
LNBTST voltage_range tone
voltage_range: Either
tone: Either
Volatile test command to force use of the ASTRA Universal LNB functions. Disable with
command. A Local Control Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
800032-01 Rev. F
, , or .
WEG STATIC
, and
LAN GATEWAY LAN SUBNET
with product ID=9 and SN=260050 is set to "Wegener" IP address mode, it's new
n1:n2:n3:n4
. Note that not all values can be legal.
for Enable, or for Disable.
E D
or .
ON OFF
or (for High and Low).
H L
or .
ON OFF
commands. Omitting the
where , , , and
n1 n2 n3
parameter shows the current static subnet mask. This
addr
36
parameter shows
mode
are integers between
n4
TESTOFF
www.wegner.com
and
0