Advertisement
Insertthe bagframestrapintothestitchedsleeve
alongthe frontedgeof the bagbottom.Seefigure
12.
Assemble the bagframestrapto the holesin the
lowerhoppertubesusingtwo1/4"x 1-1/8"clevis
pinsand3/32"haircotterpins.Seefigure12.
BAG FRAME STRAP
3/32" HAIR .........
FIGURE 12
IMPORTANT:
Do not over bend the support rods
during the following step. Over bending will cause the
spring steel rods to loose supporting
tension.
•
Assemble
the two hopper support rods as shown in
figure 14. Place the ends of the rod into the upper
and lower hopper tubes, bending the rod just
enough to fit into the holes in tubes.
HINT: Tip the hopper onto its back if you have trouble
reaching in to install the support rods.
SUPPORT
.........
RODS
_z
•
Secure the bag corners around the lower hopper
tubes by snapping the bag flaps to the bag bottom
on both sides. See figure 13.
SNAP
\
/
/
i
\
FLAP
/
FIGURE 13
FIGURE 14
•
Locate the hole in each side hopper tube and
pierce a hole through the hopper bag aligned with
the hole in each side tube. See figure 15.
SIDE HOPPERTUBE
FIGURE 15
8
Advertisement
