Advertisement
Assemble
the short end of the angle bracket to the
hitch tongue using a 5/16" x 3/4" hex bolt and 5/16"
hex lock nut. See figure 5.
Place the pivot bushing into the hole in the height
adjustment
strap. Attach the strap and spacer to
the angle bracket using the 5/16" x 3/4" truss head
bolt, a 5/16" lock washer and a 5/16" hex nut. See
figure 5.
Attach the slotted end of the height adjustment
strap to the height adjustment
handle by inserting a
5/16" x 3/4" carriage bolt through the handle and
then the strap. Assemble
a 5/16" washer and the
plastic hand knob onto the bolt. See figure 5.
HEIGHT
HEIGHT
ADJUSTMENT
ADJUSTMENT
STRAP
_
HANDLE
5116"
5/16" x 3/4" HEX BO
TRUSS
HEAD
5/16" x 3/4"
BOLT
CARRIAGE BOLT
5J
LOCK
5116"
HEX NUT
5116" HEX
LOCK NUT
PIVOT
BUSHING
5116" WASHER
ANGLE
BRACKET
FIGURE 5
Assemble
the two bag mount arms to the outside
of the sweeper housing using four 3/8" x 3/4" hex
bolts and 3/8" hex lock nuts. Use rear hole of dual
position holes in sweeper housing to install bag
mount arm. The notched side of the bag mount
arms faces upward.
See figure 6.
NOTCH
3/8" x 3/4" HEX BOLT
BAG MOUNT
ARM
3_"HEX
LOCK NUT
FIGURE6
USE REAR HOLE
•
Assemble
the hitch pin, the two hitch spacers and
the 1/8" hair cotter pin to the hitch bracket and
hitch tongue as shown in figure 7.
HITCH PIN
t
HAIR PIN COTTER.....,_,_ I
HITCH SPACERS
FIGURE 7
Advertisement
