Installing The Transparency Unit - Epson GT-12000 User Manual

Note:
Before transporting the scanner, remove the Transparency Unit
and replace the shipping screws in the outer, transportation holes.
If the unit's lamp assembly is not in its home position, you cannot
replace the shipping screws. If this is the case, reattach the unit to
the scanner, close the unit, and turn the scanner on; the unit's
lamp assembly then returns to its home position. Then turn off
the scanner and remove the Transparency Unit.

Installing the Transparency Unit

Follow the steps below to install the Transparency Unit.
1. Make sure the scanner is turned off and unplug the power
cable from the scanner.
2. Remove the document cover from the scanner by holding
the cover behind the hinge and lifting the back of the cover
straight up.
3-4
Options