Installing The Network Image Express Card - Epson Expression 636 Setup Manual

Installing the Network Image Express Card

Install the Network Image Express Card in your scanner by
following the steps below.
1. Turn off the scanner. Unplug any power cords, and then
disconnect all cables from the back panel of your scanner.
2. Remove the two screws using a cross-head screwdriver, and
then remove the plate. Be sure to keep both screws; you may
need to use them again if you re-install the shield plate.
3. Insert the Network Image Express Card in your scanner's
optional interface slot and then tighten the screws.
c
4. Initialize the Network Image Express Card. To initialize, turn
on the scanner while holding down the Reset button of the
Network Image Express Card for 10 seconds until the red
status light and green data light turn on.
Note:
Be sure to initialize the Network Image Express Card when you
insert or re-insert it in the scanner.
5. Turn off the scanner.
Caution:
Do not install or uninstall the Network Image Express Card
from the scanner while the scanner is turned on; otherwise
damage may occur.
27
Options