Setting The Clock - Sharp CD-XP160W Operation Manual

Setting the clock

CD-XP160W
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK button and within 8 seconds, press the
MEMORY button.
3 Within 30 seconds, press the PRESET (
select 24-hour or 12-hour display and then press the MEM-
ORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it
has been reset. [Refer to "Clearing all the memory (reset)" on
page 27 for details.]
13
4 Within 30 seconds, press the PRESET (
adjust the hour and then press the MEMORY button.
Press the PRESET (
z
by 1 hour. Hold it down to advance continuously.
When the 12-hour display is selected, "AM" will change au-
z
tomatically to "PM".
5 Within 30 seconds, press the PRESET (
just the minutes and then press the MEMORY button.
Press the PRESET (
z
by 1 minute. Hold it down to advance continuously.
The hour will not advance even if minutes advance from "59"
z
to "00".
To confirm the time display:
or ) button to
Press the CLOCK button.
The time display will appear for about 8 seconds.
Note:
The time will flash at the push of the CLOCK button when the AC
power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the "0:00" is not
flashing in step 2, step 3 (for selecting the 24-hour or 12-hour dis-
play) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 27 for details.]
2 Perform "Setting the clock" from the beginning.
02/5/27
or ) button to
or ) button once to advance the time
or ) button to ad-
or ) button once to advance the time
CD-XP160W(SCA)E2..fm