Sharp CD-XP160W Operation Manual page 11

Setting the FM/AM span selector
The International Telecommunication Union (ITU) has established
that member countries should maintain either a 100 kHz or a 50 kHz
interval between broadcasting frequencies of FM stations and 10
kHz or 9 kHz for AM station. The illustration shows the 50/9 kHz
zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, set the SPAN SELECTOR switch (on the rear
panel) to the interval (span) of your area.
To change the tuning zone:
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Set the SPAN SELECTOR switch (on the rear panel) as follows.
For 100 kHz FM interval (10 kHz in AM)
z
For 50 kHz FM interval (9 kHz in AM)
z
3 Whilst pressing down the TUNER (BAND) button and the DISC
SKIP button, press the ON/STAND-BY button until "CLEAR" ap-
pears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
Demonstration mode
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode),
press the EQUALIZER/X-BASS/DEMO button. The demonstration
mode will be cancelled and the display will disappear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the EQUAL-
IZER/X-BASS/DEMO button again.
Note:
When the power is on, the EQUALIZER/X-BASS/DEMO button can
be used to select the pre-programmed equaliser and extra bass
modes.
To turn the power on
Press the ON/STAND-BY button to turn the power on.
100/10
50/9
After use:
Press the ON/STAND-BY button to enter the power stand-by
mode.
02/5/27 CD-XP160W(SCA)E1.fm
CD-XP160W
10