Sharp CD-XP160W Operation Manual page 24

Recording to a cassette tape (continued)
CD-XP160W
Recording from the radio
T
1
Tune in to the desired station (see page 18).
2
Load a cassette into the TAPE 1 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button of TAPE 1.
4
Press the button of TAPE 1,
which also engages the
ton.
5
Press the button of TAPE 1 again to begin recording.
To stop recording:
Press the button of TAPE 1.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
Erasing recorded tapes
T
1 Load the tape to be erased into the TAPE 1 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE button.
3 Press the button of TAPE 1, which also engages the
to begin erasing.
Notes:
Do not connect anything to the MIC socket.
z
Make sure that the TAPE 2 is not in use.
z
23
T
You can record from TAPE 2 to TAPE 1.
1
2
but-
3
4
5
6
To stop dubbing:
Press the
button
02/5/27
Dubbing from tape to tape
Press the ON/STAND-BY button to turn the power on.
Load a prerecorded cassette
into the TAPE 2 cassette
compartment. Insert a blank
tape into the TAPE 1 cassette
compartment.
It is recommended that the record-
ing tape is the same length as the
master tape.
Press the TAPE button.
Press the button of TAPE 1.
Press the button of TAPE 1, which also engages the
button.
Press the button of TAPE 2.
The button of TAPE 1 will be released automatically and dub-
bing from TAPE 2 to TAPE 1 will begin.
button of TAPE 1.
CD-XP160W(SCA)E3.fm