Epson ELPMB24 Installation Manual page 8

2. Attaching the arm unit to the wall plate
1) Route the cables through the arm unit as shown below.
2) Attach the hook on the arm plate to the bar on the wall plate.
Be careful not to pinch cables between the arm plate and the wall plate.
3) Secure the arm plate temporarily using two M8
3. Attaching the projector plate to the projector
1) Place the projector upside down.
2) Attach the projector plate to the projector using the hexagon wrench (M4) and five M4
Projector plate
Warning
If you use adhesives to prevent the screws from loosening or things such as lubricants or oils on the mount, the
case may crack and this could cause the projector to fall. It could cause personal injury or property damage. Do
not use adhesives, lubricants or oils to install or adjust the mount.
q
Tighten the screws firmly.
8
×
16 mm hexagon socket head cap bolts.
Arm plate
Arm unit
Wall plate
Bar of the wall plate
M8 × 16 mm hexagon
socket head cap bolt
(2 pcs.)
×
12 mm bolts.
M4 × 12 mm hexagon socket head
cap bolt (5 pcs.)
Projector lens side
Power cable