Configure The Settings Relating To The Mail Notification [Notification] - Panasonic WV-SP302 Operating Instructions Manual

Configure the settings relating to the mail notification [Notification]

Click the [Notification] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The settings relating to the alarm mail can be configured. It is necessary to configure the settings of the mail server
to perform the mail notification. (☞ Page 75)
■ Mail notification
[Mail server >>]
When "Mail server >>" is clicked, the [Mail] tab of the
"Server" page will be displayed. (☞ Page 75)
[Mail notification]
Select "On" or "Off" to determine whether or not to pro-
vide notification by e-mail according to the settings for
the "Alarm" and "Diag." checkboxes of "Destination of
notification" below.
• When an alarm is detected ("Alarm")
• When a notification of the remaining capacity of the
SD memory card has been provided ("Diag.")
• When the SD memory card has become full ("Diag.")
• When the SD memory card cannot be recognized
("Diag.")
Default: Off
[Alarm image attachment]
Select "On" or "Off" to determine whether or not to
attach an image to the mail to be sent when an alarm is
detected.
Default: Off
Note:
• The settings for "Image capture size" of the "Alarm
image" section on the [Alarm] tab (☞ page 61) will
be applied to the size of the image to be attached.
■ Destination of notification
[Address 1] - [Address 4]
Enter the destination mail address. Up to 4 destination
addresses can be registered.
"Alarm" checkbox: When the checkbox is checked,
the mail notification will be performed upon an
alarm occurrence.
"Diag." checkbox: When the checkbox is checked, the
mail notification will be provided in the following
cases.
• When notification of the remaining capacity of
the SD memory card has been provided
• When the SD memory card has become full
• The SD memory card cannot be recognized
"Destination address": Enter the destination address.
To delete the registered address, click the [Delete] but-
ton respective to the desired address.
Available number of characters: 3 - 128 characters
[Mail subject]
Enter the mail subject.
Available number of characters: 0 - 50 characters
[Mail body]
Enter the mail body.
Available number of characters: 0 - 200 characters
Note:
When the SD memory card becomes full, notifica-
tion mail will be sent with the following message.
• When the SD memory card has become full:
"The SD memory card is full."
• When mounting of the SD memory card failed:
"The SD memory card cannot be recognized."
67