Panasonic WV-SP302 Operating Instructions Manual page 79

■ IPv6 network
[Manual]
Select "On" or "Off" to determine whether or not to
manually configure the IP address for IPv6 network
(IPv6 address).
On: Enter an IPv6 address manually.
Off: Manual entry of an IPv6 address will become
unavailable.
Default: Off
[IP address(IPv6)]
When "On" is selected for "Manual", manual entry of
the IPv6 address is required.
Do not enter an address already in use.
Note:
• When connecting to the manually configured IPv6
address beyond the router, use an IPv6 compatible
router and turn on the automatic IPv6 address
assignment function. In this case, it is necessary to
configure IPv6 address including prefix information
provided from the IPv6 compatible router. Refer to
the operating instructions of the router in use for fur-
ther information.
■ Common
[DNS]
Determine how to set the address of the DNS server by
selecting "Auto" (obtain the address automatically) or
"Manual" (enter the address of the DNS server). When
"Manual" is selected, it is necessary to configure the
settings for the DNS.
When using the DHCP function, it is possible to obtain
the DNS address automatically by selecting "Auto".
Refer to the network administrator for further informa-
tion about the settings.
Default: Manual
[Primary server address], [Secondary server
address]
When "Manual" is selected for "DNS", enter the IP
address of the DNS server.
Refer to the network administrator about the IP address
of the DNS server.
Note:
• It is impossible to use both an IPv4 DNS server and
an IPv6 DNS server.
[HTTP port]
Assign the port numbers independently.
The following port numbers are unavailable since they
are already in use.
Available port number: 1 - 65 535
Default: 80
<Port numbers already in use>
20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 123, 161, 162,
554, 995, 10 669, 10 670, 59 000 - 61 000
[Line speed]
Select the line speed for data transmission from the fol-
lowing. It is recommended to use with the default
"Auto".
Auto: Line speed will be applied automatically.
100M-Full: 100 Mbps full-duplex
100M-Half: 100 Mbps half-duplex
10M-Full: 10 Mbps full-duplex
10M-Half: 10 Mbps half-duplex
Default: Auto
[FTP access to camera]
Select "Allow" or "Forbid" to determine whether to
allow or forbid the FTP access to camera.
Default: Forbid
[Bandwidth control(bit rate)]
Select the total bit rate for data transmission from the
following.
Unlimited / 64kbps / 128kbps / 256kbps / 384kbps /
512kbps / 768kbps / 1024kbps / 2048kbps / 4096kbps
/ 8192kbps
Default: Unlimited
Note:
• When selecting "64kbps", select "Off" for "Audio
transmission/reception" on the [Audio] tab. (☞ Page
57)
• Select "128kbps" or a faster rate to carry out the
live transmission of JPEG images and the FTP peri-
odic image transmission simultaneously.
• When "Bandwidth control(bit rate)" is set low, taking
a picture using the one shot button may not function
depending on the use environment.
In this case, select "QVGA" for "Image capture size"
of "JPEG" on the [JPEG/H.264] (or [JPEG/MPEG-4])
tab or set "Image quality" of "JPEG" lower.
79