13 Configure the alarm settings [Alarm]
5.
To delete the VMD area, click the [Delete] button corresponding to the area to be deleted.
→
The outline of the respective VMD area will disappear.
6.
Click the [Set] button.
→
The edited settings will be applied.
13.7 Configuration of the settings relating to the mail
notification [Notification]
Click the [Notification] tab on the "Alarm" page. (®page 40, page 42)
The settings relating to the alarm mail can be configured. It is necessary to configure the settings of the mail
server to perform the mail notification. (®page 130)
Mail notification
[Mail server >>]
When "Mail server >>" is clicked, the [Mail] tab of the "Server" page will be displayed. (®page 130)
[Mail notification]
Select "On" or "Off" to determine whether or not to provide notification by e-mail according to the settings for
the "Alarm" and "Diag." checkboxes of "Destination of notification" below.
–
When an alarm is detected ("Alarm")
:
SW559
SW559
SP509
SP509
–
When a notification of the remaining capacity of the SD memory card has been provided ("Diag.")
–
When the SD memory card has become full ("Diag.")
–
When the SD memory card cannot be recognized ("Diag.")
•
Default: Off
118
Operating Instructions