Sharp Notevision PG-M20X Operation Manual page 33

3
Press ,
remote control to select the
INPUT Mode.
• Pressing
on the projector switches
the inputs in the following order:
¡ INPUT 1 ¡ INPUT 2 ¡ INPUT 3
Note
• When no signal is received, "NO
SIGNAL" will be displayed. When a
signal that the projector is not pre-
set to receive is received, "NOT
REG." will be displayed.
About the INPUT Modes
INPUT 1 Used for projecting im-
(RGB/ ages from equipment that
Component) sends RGB signals or
Component signals con-
nected to the DVI-DIGI-
TAL/ANALOG input port.
INPUT 2 Used for projecting im-
(S-Video) ages from equipment
connected to the S-
VIDEO input terminal.
INPUT 3 Used for projecting im-
(Video) ages from equipment
connected to the VIDEO
input terminal.
4
Press or
control to adjust the volume of
the speaker.
Note
• Pressing
will raise the volume.
Pressing will lower the volume.
• On the projector, the volume can be
adjusted by pressing
•
, on the projector operate
as cursor buttons (
selecting setup or adjustment
functions while adjusting menus or
the lens.
or on the
on the remote
or .
, ) when
"On-screen Display (Example)
INPUT 1 Mode
Using
DVI digital
Using Analog
RGB
Using
Component
INPUT 2 Mode
Using S-Video
INPUT 3 Mode
Using Video
VOLUME
buttons
-29