Only Part Of The Image Is Displayed (Large/Small) - Epson PowerLite S1 User Manual

When You Suspect a Problem

Only part of the image is displayed (large/small)

• Change the resolution for the notebook
computer or computer with an LCD screen.
• Is the aspect ratio set correctly?
• Has the computer been set for dual display?
• Has the correct resolution been selected?
• Has the position been adjusted correctly?
• Is the E-Zoom function being used to enlarge
the image?
Change the resolution so that the image is displayed in the whole of the
projection area, or set the image signal to external output only. See
the Input Source" on page 28.
Press the [Aspect] button to set the aspect ratio to 4:3. See
widescreen (changing aspect ratio)" on page
If dual display has been activated in the Display Properties of the connected
computer's Control Panel, the projector will only display about half of the image
on the computer screen. To display the whole of the image on the computer
screen, turn off the dual display setting. Refer to the video driver manual for the
computer's monitor for further details.
Set the computer so that the signals that are output are compatible with this
projector. Please refer to your computer's documentation for further details. See
"Supported Display Resolutions" on page
Use the "Setting" → "Screen" → "Position" configuration menu to correctly
adjust the display position. See "Setting menu" on page
Press the [Esc] button on the remote control to cancel E-Zoom.
See "E-Zoom" on page 31.
"Selecting
"Projecting in
31.
64.
39.
49