Direct Key Programming; Direct Key - Sharp ER-A770 Instruction Manual

Direct Key Programming

Use the following procedure to select direct-key programming:

Direct key

You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to
10 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below.
Procedure
Select a pertinent key no. from the
key numbers list.
In the case of selecting "061 DIRECT PLU"
• TYPE (Use the selective entry)
PLU: Assigns the key as a direct PLU key.
DEPT: Assigns the key as a direct department key.
NOTE
• You can also select a direct PLU key by pressing the
corresponding key when the PLU has been assigned directly on
the keyboard instead of selecting the key from the menu.
• When selecting a department, the screen on which a
department code is to be entered (the message "DEPT.
CODE") will appear.
• LEVEL1 through 10 (Use the numeric entry)
Enter a PLU code for each level. For example, if you want to
use this key as PLU code 1 (level 1) and PLU code 101
(level 2), enter 1 for "LEVEL1" and 101 for "LEVEL2."
Key numbers
12 24 36 48 60
11 23 35 47 59
10 22 34 46 58
9 21 33 45 57
8 20 32 44 56
7 19 31 43 55
6 18 30 42 54
5 17 29 41 53
4 16 28 40 52
3 15 27 39 51
2 14 26 38 50
1 13 25 37 49
NOTE
• You can assign departments and PLUs only the "Departments
and PLUs programmable area" shown above.
• You cannot assign a department or a PLU to the position to
which a function key has been assigned.
72 84 96 108 120 132 144 156
71 83 95 107 119 131 143 155
70 82 94 106 118 130 142 154
69 81 93 105 117 129 141 153
68 80 92 104 116 128 140 152
67 79 91 103 115 127 139 151
66 78 90 102 114 126 138 150
65 77 89 101 113 125 137 149
64 76 88 100 112 124 136 148
63 75 87 99 111 123 135 147
62 74 86 98 110 122 134 146
61 73 85 97 109 121 133 145
Departments and PLUs programmable area
151