Direct Key Programming; Direct Key - Sharp UP-820F Instruction Manual

Direct Key Programming

Use the following procedure to select direct-key programming:

■ Direct key

You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to
10 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below.
Procedure
▼
Select a pertinent key no. from the
key numbers list.
▼
▼
The screen continues.
146
In the case of selecting "044 DIRECT PLU"
• TYPE (Use the selective entry)
PLU: Assigns the key as a direct PLU key.
DEPT: Assigns the key as a direct department key.
NOTE
• You can also select a direct PLU key by pressing the
corresponding key when the PLU has been assigned directly on
the keyboard instead of selecting the key from the menu.
• When selecting a department, the screen on which a department
code is to be entered (the message "DEPT. CODE") will appear.
• LEVEL1 through 10 (Use the numeric entry)
Enter a PLU code for each level. For example, if you want to
use this key as PLU code 1 (level 1) and PLU code 101 (level
2), enter 1 for "LEVEL1" and 101 for "LEVEL2."
Key numbers
25 34 43 52
RECEIPT JOURNAL
8 16 24 33 42 51
7 15 23 32 41 50
6 14 22 31 40 49
5 13 21 30 39 48
4 12 20 29 38 47
3 11 19 28 37 46
2 10 18 27 36 45
1 9 17 26 35 44
Departments and PLUs programmable area
NOTE
• You can assign departments and PLUs only for the "Departments
and PLUs programmable area" shown above.
• You cannot assign a department or a PLU to the position to
which a function key has been assigned.
61 70 79 88 97 106 115
60 69 78 87 96 105 114
59 68 77 86 95 104 113
58 67 76 85 94 103 112
57 66 75 84 93 102 111
56 65 74 83 92 101 110
55 64 73 82 91 100 109
54 63 72 81 90 99
53 62 71 80 89 98
124 133 142
123 132 141
122 131 140
121 130 139
120 129 138
119 128 137
118 127 136
108
117 126 135
107
116 125 134