Correcting Computer Images; Shutting Down The Projector - Epson PowerLite 732c User Manual

note
You must be projecting an
image for this button to have
any effect. The button
Auto
works only with computer
images.
note
You can set the projector to
automatically turn off the
projector lamp and enter
"sleep mode" when it has
not received any signals for
30 minutes. This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the P button.
Power
If you are done using the
projector, unplug the power
cord. To enable sleep mode,
see page 58.
Displaying and Adjusting the Image
24

Correcting Computer Images

If you're connected to a computer and the image doesn't look right,
press the button on the remote control or the
Auto
the projector. This automatically resets the projector's tracking, sync,
resolution, and position settings.
If the button doesn't correct the problem, you may need to
Auto
adjust the tracking or sync using the projector's Signal menu. See
page 50 for more information.

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off any equipment plugged into the projector.
2. To turn off the projector, press the red P
remote control or projector.
You see a confirmation message. (If you don't want to turn it off,
press any other button.)
button on
Enter
button on the
Power