Shutting Down The Projector; Correcting Computer Images - Epson PowerLite 9300i Quick Manual

EPSON PowerLite 9300i Projector
Using QuickCorner
Use QuickCorner to correct the image shape when it's uneven
on the top and bottom, or on all sides.
1. Press the button on the remote control (or on the
Menu
projector's control panel).
2. Select the menu and press
Setting
3. From the Setting menu, select
4. Select and press
Quick Corner
You see this screen:
5. Press the button to select the corner you want to
Enter
adjust.
6. Use the pointer button on the remote control (or the
arrow buttons on the projector) to adjust the shape.
7. Repeat steps 5 and 6 as needed to adjust any remaining
corners.
8. When done, press
ESC

Correcting Computer Images

If you've connected a computer and the image doesn't look
right or fit properly on the screen, press the
the remote control (or the
projector's control panel). This automatically resets the
projector's tracking, sync, resolution, and position settings.
Note: You must be projecting an image for this button to have
any effect. The button works only with computer images.
Auto
10 EPSON PowerLite 9300i Projector
-
.
Enter
and press
Keystone
.
Enter
to exit the menu system.
button on
Auto
button on the
Auto/Enter
Auto button

Shutting Down the Projector

When you've finished using the projector, follow the
recommended procedure to shut it down. This extends the life
of the lamp and protects the projector from possible
overheating.
. Note: When the projector has not received any input signals for
Enter
30 minutes, it automatically turns off the projector lamp and
enters sleep mode. This conserves electricity, cools the projector,
and extends the life of the lamp. If you are done using the
projector, unplug the power cord. If you want to start projecting
again, press the
You can turn off sleep mode using the
Setting menu. If
the Advanced1 menu), the lamp will turn off but the projector will
not go into full standby mode.
Follow these steps to turn off the projector:
1. If you're using a computer or notebook, shut it down first.
Otherwise you may not be able to see your computer's
display to shut it down properly.
2. To turn off the projector, press the red P
the projector or remote control. You see a confirmation
message. (If you don't want to turn it off, press any other
button.)
3. Press the P
orange for about a minute as the projector cools down.
When the projector has finished cooling, the orange light
stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the
orange light stops flashing. Then press the P
button.
4. Turn off and disconnect any equipment plugged into the
projector.
5. Replace the lens cap, retract the feet, and unplug the power
cord.
Caution: To avoid damaging the projector or lamp, never
unplug the power cord when the power light is green or
flashing orange.
10/03
button.
Power
Sleep Mode
has been set to
Standby Mode
Power
button
button again. The power light flashes
Power
option in the
(in
Network ON
button on
Power
Power