Using The Infrared Remote Control - Sharp VL-E41X Operation Manual

control
USING THE INFRARED
REMOTE CONTROL
remote control to opera e the VIEWCAM
Use the
from a distance, such as when $ ou want to record
yourself in a scene, or when the VIEWCAM is con-
nected to a TV for use as a VCR.
Set the Operate switch to CAMERA or VCR.
2
When CAMERA is selected
Press the MENU button to display MENU 2.
If MENU 1 is displayed, press the PAGE button
When VCR is selected
Press the MENU button to display the menu.
3
Make sure that the "REMOTE" menu item is set
to "ON".
In Camera mode In VCR mode
l
AUTO CORRECT BDIT
l
SCRBBN' NORMAL
PEED
Press the MENU button to turn off the menu.
4
Aim the remote control at the photoreceptor of
the VIEWCAM, and press control buttons to
operate the VIEWCAM.
Notes:
. Be careful not to allow direct sunlight or bright light from
interior rllumination to fall onto the VIEWCAM's photore-
ceptor, as this may prevent the remote control from
operating properly.
Be sure that there are no obstacles between the remote
l
control and the VIEWCAM's photoreceptor.
When the "REMOTE" item setting is changed in either
l
Camera or VCR mode, the setting for the other mode is
automatically set to the same.
The lithium battery normally lasts about 6 months. It can
l
be shorter under some operating conditions. When the
lithium battery is dead and the remote control does not
operate, replace the battery with a new one by following
the instructions on page 10.
USING THE STAND
Pull out the stand and lock it into position when you
put the VIEWCAM on a table or other flat surface. To
stabilize the VIEWCAM, make sure that the VIEW-
CAM's camera part stands vertically as shown.
Cautions:
Protect the stand from strong forces. Otherwise it may
l
break.
Press the stand in the direction of the arrow to fold it in,
l
as shown.
ON