Connection To Tv Without Audio/Video Jacks - Sharp VL-E41X Operation Manual

/ ( o p t i o n a l
RF converter
(optional
accessory)
Connect to out- L-J
door or indoor
antenna or cable
To ANTENNA IN
If your TV's antenna input is connected to a VCR
Disconnect the cable between the TV and VCR, and insert
the RF converter between them, as shown below.
A N T
CONNECTION TO TV WITHOUT
1
AUDIO/VIDEO JACKS
AV pack
Use the AV pack, RF converter, and 75ohm coaxial
cable, available as optional acces & ories.
1
Follow the procedure described under
"ATTACHING THE AV PACK" on page 37 and
install the AV pack (with a battery pack or the
connecting plate mounted) on the VIEWCAM.
2
To view the output from your camcorder on the
TV, you
must select an unused channel on your
TV
and tune it to the output of the
(factory preset to channel 0).
3
Unplug the antenna cable from the TV and plug
it into the ANTENNA IN terminal on the RF con-
verter.
Coaxial cable
(optional
4
Plug the 75ohm coaxial cable into RF OUT ter-
accessory)
minal on the RF converter and the 75-ohm coax-
ial antenna terminal on the TV.
5
Plug the RF converter cable into the audio and
video jacks on the AV pack.
6
Slide the VIEWCAM's Operate switch to VCR.
7
Load a video cassette (cassette window facing
outward), and then press the PLAY button (a).
Precautions:
Use only the VR-X30RF RF converter (optional accessory)
l
with this VIEWCAM.
The RF converter is a sealed unit. Do not attempt to open
l
or modify it. Do not damage, drop or subject the unit to
vibration.
Unplug the RF converter during lightning storms.
l
Notes:
To resume normal TV operation, set the Operate switch to
l
OFF on the VIEWCAM, or unplug the RF converter cable
from the AV pack if it is still mounted on the VIEWCAM.
The picture may be disturbed during video search or still
l
picture playback. This does not imply a defect in the
VCR
RF
converter
38