Powering The Viewcam From An Ac Outlet; Using The Car Battery Adaptor/Battery Charger (Optional Accessory) - Sharp VL-E41X Operation Manual

light& socket
DC cable
tery Adaptor/Battery
r VR-PlOOCH (optional
accessory)
POWERING THE VIEWCAM
FROM
AN AC OUTLET
1 Plug the DC cable of the connecting plate sup-
plied with the AC adaptor into the DC OUT jack
on the AC adaptor.
ATE indicator on the AC adaptor will light.
Caution:
The supplied AC adaptor/battery charger (UADP-
l
0179GEZZ) is specially designed for use with the VIEW-
CAM, and should not be used as a power supply for
other camcorders,
USING THE CAR BATTERY
ADAPTOR/BATTERY CHARGER
(OPTIONAL ACCESSORY)
Insert the plug into the cigarette lighter socket.
The OPERATE indicator will light.
Plug the DC cable from the supplied connecting
plate into the DC OUT jack on the car battery
adaptor/battery charger.
Mount the connecting plate on the VIEWCAM.
The battery pack can be recharged by using the
car battery adaptor/battery charger in basically
the'same manner as the AC adaptor/battery
charger (see page
Note:
If you power the VIEWCAM from the car battery for an
l
extended period of time, the battery will be drained and
restarting the engine may be difficult. An average fully-
charged car battery has a capacity of 50 ampere-hour,
which will allow 20 hours of VIEWCAM usage while still
leaving half the battery's capacity.
Cautions:
Use in only DC 12V or 24V negative ground system cars
l
Positive-ground car batteries CANNOT BE USED. Check
your car operation manual or consult a local car dealer.
Charge only SHARP model BT-77, BT-70, BT-BH70, BT-
l
80, or BT-BH85 battery packs. Other types of batteries
may burst, causing personal injury and damage.
12