Preparation; Installing The Memory Backup Battery; Installing The Battery In The Remote Control - Sharp VL-E41X Operation Manual

2
3
INSTALLING THE MEMORY
BACKUP BATTERY
the battery mounting panel: using a pointed ob-
ject such as the point of a pen, push the cover
release "@" down and to the left, and then pull
outward.
Insert the lithium battery, with the + side facing
outward.
Close the cover: press the cover in until it clicks
into place.
REPLACE BATTERY WITH SHARP TYPE CR2025
(PART NO. UBATL0006TAZZ) OR SONY ENER-
GYTEC TYPE CR2025 ONLY. USE OF A DIFFER-
ENT BATTERY MAY PRESENT A RISK OF FIRE
OR EXPLOSION.
CHILDREN. IF SWALLOWED, CONSULT A PHY-
SICIAN IMMEDIATELY FOR EMERGENCY
TREATMENT.
TREATED OR INSTALLED WITH POLARITY RE-
VERSED. DO NOT RECHARGE, DISASSEMBLE
OR DISPOSE OF IN FIRE.
Cautions:
Be sure that the + and - poles are correctly oriented
l
when the battery is installed.
Do not short-circuit, recharge, disassemble or heat the
l
battery.
Should the battery leak, wipe the battery compartment
l
and its cover clean, and then insert a new battery.
Notes:
The lithium battery is used to back up the calendar and
l
other memory functions.
. The battery will last one year of normal usage.
Replace the battery with a new CR2025 cell when the
l
time.
INSTALLING THE BATTERY IN
THE REMOTE CONTROL
To open the battery compartment, press the tab
on the left side toward the centre, and slide the
tray out.
Install the supplied CR2025 lithium battery with
its + side matching the @ marked side of the
battery holder.
Replace the lid by sliding it in the direction of the
arrow. Make sure that the @ side faces the
back of the remote control.
10