Powering The Viewcam From An Ac Outlet - Sharp VIEWCAM VL-AH150U Operation Manual

Preparation
Powering the VIEWCAM from
an AC Outlet
Caution:
• The supplied AC adapter is specially designed
for use with this VIEWCAM, and should not be
used as a power supply for other camcorders.
1
Insert the AC plug of the AC adapter into
a power outlet.
2
Make sure that the Power switch is set
to OFF.
3
Open the terminal cover and insert the
DC plug of the AC adapter into the DC
IN jack on the VIEWCAM.
DC IN jack
To power
outlet
4
Hold down the Lock
button and slide the
Power switch to
CAMERA or VCR.
9
Cautions:
• BEFORE REMOVING THE DC PLUG, ALWAYS
• Remove the DC plug from the VIEWCAM if you
• When removing the plugs, grasp the plug, not
Note:
• Close the terminal cover after use.
Power switch
Terminal cover
Lock button
STOP THE TAPE AND TURN THE POWER OFF.
If you remove the DC plug during recording or
playback, the tape will remain wound around the
video head drum, potentially causing damage to
the tape.
will not use the VIEWCAM for a long period of
time.
the cable.