Savin 2555 Copy Reference Manual page 45

What to Do If Something Goes Wrong
Connect Copy
Machine Status
The [Connect] key does not
appear on the display.
5
252
Problem/Cause
The main power switch on
the sub-unit is off.
The operation switch on
the sub-unit is off.
The master unit is not in
Copy mode (i.e., in Docu-
ment Server mode).
The master unit is in Inter-
rupt mode.
The master unit is in Job
Preset mode.
Action
Turn on the sub-unit main
power switch.
Press the operation switch
on the right side of the con-
trol panel. The On indica-
tor will goes on.
Note
The machine will be
ready to operate about
five minutes after turn-
ing power on.
Press the {Copy/New Job}
key on the master unit to
switch to Copy mode.
Press the {Interrupt} key on
the master unit to exit In-
terrupt mode.
Exit Job Preset mode in one
of the following ways.
If you are still selecting
copy settings and copy-
ing has not started yet:
Press the [Cancel] key
then remove the origi-
nals set in the master
unit document feeder.
If Job Preset mode is in
progress:
Press the {Clear/Stop}
key, follow the instruc-
tions on the display
then press the [Cancel]
key.
Reference
See P.83 "Job Preset".