Table of Contents
Advertisement
Inserting the Batteries
The following batteries can be used in the camera. Please choose which kind to use according to your needs.
Battery Type
AA Alkaline Batteries
(LR6) (included)
Rechargeable Battery
(DB-43 or DB-40)
(sold separately)
Nickel-Hydrogen Battery
(available in stores)
Below is an indication of the number of images you can take.
Battery Type
AA Alkaline Batteries (LR6)
Rechargeable Battery
The number of shots is based on a temperature of 22 degrees celsius, shooting at 30-second intervals and one out of every
two being shot with the flash.
If you set the camera to the Power-Save mode, the number of shots you can take will increase.
In addition to the batteries, you can use the AC Adaptor (sold separately).
When the batteries wear out
Just before the batteries wear out,
batteries with a fresh set.
• Other batteries, such as manganese dry cell (R6) and Ni-Cd, cannot be used.
• Please remove the batteries if you are not going to use it for a long period of time.
• The batteries may become hot after extended use. Touching the batteries immediately after use could result
in burns to your fingers.
• With AA Alkaline Batteries (LR6), the number of shots may differ depending on the batteries.
You can obtain them anywhere, so they are convenient for travel.
However, in a low-temperature environment the number of shots you can take will
decrease. Warm the batteries before use.
This is a lithium-ion battery. This is economical because you can recharge it using the
battery charger BJ-2 (sold separately) and use it over and over again. They last a long time,
so they are convenient for travel.
This is economical because you can recharge it and use it over and over again. Please use
a recharger available in stores.
Number of Shots Number of Shots (In the Synchro-Monitor Mode: see p.21)
approx. 50
approx. 350
is displayed on the LCD Monitor. When this happens, replace the
Chapter 1 / Section 1 Getting Started
Feature
approx. 60
approx. 400
Insert the batteries following these steps.
Make sure the camera power is off.
Slide the battery/card cover to open.
The cover slides two steps.
Slide the cover two steps to open.
Insert the two batteries, making sure they are
facing the correct way.
9
Advertisement
Table of Contents
