Setting The Date And Time - Ricoh Caplio G3 Operation Manual

Setting the Date and Time

You can take still images with the time or date stamped onto the picture.
Immediately after purchasing the camera, the date and time settings will not be correct, so be sure to
set the date and time before using this feature.
To set the date and time, follow the steps below.
Buttons used here
Make sure the power is on and then turn the
Mode Dial to 1 (Setup Mode).
The Setup screen is displayed on the LCD Monitor.
Press the " button to select [DATE
SETTINGS] and then press the O button.
If the batteries are removed for about two weeks, the date and time settings will be lost. These settings must be
made again.
Chapter 1 / Section 1 Getting Started
Set the year, month, date and time by
pressing !"#$.
If you hold down the
decrease the value quickly.
In [FORMAT], choose the Date and Time
format.
Check the display on the bottom of the
screen and then press the O button.
Once you have set the date and time, the display
returns to the Setup screen.
14
!"
buttons, you can increase/