Table of Contents
Advertisement
When the Indicators Provide No Help
If any of the following problems occur and the indicators do not offer a solution, refer to the pages
given for each problem.
Problems relating to images
No images appear
Projection does not start, the projection area is
completely black, the projection area is completely blue,
etc.
Problems such as interference, distortion or black &
white checked patterns appear.
Only part of the image is displayed.
Problems when projection starts
Power does not turn on
Problems relating to images
No images appear
Have you pressed the [Power]
button?
Are all of the indicators
switched off?
Is blank mode active?
Is a video signal being input?
Are the image signal format
settings correct?
Have the configuration menu
settings been made correctly?
See below
p.32
p.33
p.33
p.33
p.35
Press
on the remote control or
Disconnect the power cable and then reconnect it.
Setup Guide
Check the circuit breaker to see if power is being supplied.
Press
on the remote control to cancel the blank function.
Check that the power for the connected equipment is turned on. If the
"Message" menu command has been set to "ON", messages relating to
the image signals will be displayed.
"Setting" - "On-Screen Display" - "Message" p.20
Use the "Video Signal" menu command to select the signal format
which matches the connected signal source.
"Setting" - "Input Signal" - "Video Signal" p.21
Try resetting all of the current settings.
The whole image appears purplish or
greenish, images are black & white, colours
appear dull, etc.
(Computer monitors and LCD screens have
p.32
different colour reproduction performance,
so that the colours projected by the projector
and the colours appearing on the monitor
may not necessarily match, but this is not a
sign of a problem.)
on the projector's control panel.
Problem Solving
p.34
p.34
p.35
p.35
p.22
31
Advertisement
Chapters
Table of Contents
