Image Colours Are Not Right; Images Appear Dark - Epson dreamio EMP-TW200 User Manual

Problem Solving
Has the "Position" setting
been adjusted correctly?
Has the computer been set for
dual display?
Only when projecting
computer images
Has the correct resolution
been selected?
Only when projecting
computer images

Image colours are not right

Are the image signal format
settings correct?
Are the cables connected
correctly?
Has the image Contrast
been adjusted correctly?
Has the colour been adjusted
correctly?
Have the colour intensity and
tint been adjusted correctly?
Only when projecting
images from a video
source

Images appear dark

Has the image brightness been
adjusted correctly?
Has the image contrast
been adjusted correctly?
Is the lamp due for
replacement?
34
Use the "Position" menu command to make the adjustment.
"Setting" - "Screen" - "Position" p.18
If dual display has been activated in the Display Properties of the
computer's Control Panel, the projector will only project about half of
the image on the computer screen. To display the whole of the image on
the computer screen, turn off the dual display setting.
Computer video driver documentation
Set the computer so that the signals that are output are compatible with
this projector.
"List of Supported Monitor Displays" p.41,
Computer documentation
If a composite video or S-Video
If projection does not occur when the "Video Signal" menu command is
set to "Auto", select the signal format that matches the signal source.
"Setting" - "Input Signal" - "Video Signal" p.21
If the signal source is connected to the [InputA] or [D4] port
Use the "Input Signal" menu command to set the signal format that
matches the signal that is being projected from the connected
equipment.
"Setting" - "Input Signal" p.21
You can also press or
format. Setup Guide
Check that all of the cables required for projection are securely
connected. Setup Guide
Use the "Contrast" or "White Level" menu command to adjust the
contrast.
"Image" - "Picture Quality" - "Input Adjustment" p.16
Use the "Color Adjustment" menu command to adjust the colour.
"Image" - "Color Adjustment" p.17
Use the "Color Intensity" and "Tint" menu commands to adjust the
colour and tint.
"Image"- "Picture Quality" - "Color Intensity", "Tint" p.16
Use the "Input Adjustment" and "Brightness" menu commands to make
the adjustments.
"Image" - "Picture Quality" - "Input Adjustment", "Brightness" p.16
Use the "Contrast" or "White Level" menu command to adjust the
contrast.
"Image" - "Picture Quality" - "Input Adjustment" p.16
When the lamp is nearly due for replacement, the images will become
darker and the colour quality will become poorer. When this happens,
the lamp should be replaced with a new one.
signal is being input
on the remote control to select the
p.38