Important Message; Specifi Cations; General Safety Information - Regency ULTIMATE U37-NG1 Owners & Installation Manual

INSTALLATION

IMPORTANT MESSAGE

SAVE THESE
INSTRUCTIONS
The ULTIMATE Rear Vent Direct Vent Freestanding
Gas Stove must be installed in accordance with these
instructions. Carefully read all the instructions in this
manual fi rst. Consult the building authority having
jurisdiction to determine the need for a permit prior
to starting the installation.
Note: Failure to follow the instructions could
cause a malfunction of the heater which
could result in death, serious bodily in-
jury, and/or property damage. Failure to
follow these instructions may also void
your fi re insurance and/or warranty.
SPECIFICATIONS
Fuels: U37-NG1 is approved for use with natural
gas.
U37-LP1 is approved for use with liquefi ed
petroleum gases (propane).
Electrical: 120 V A.C. system.
Circulation Fan: Variable speed, 125/75.
Log Sets: Ceramic fi bre, 7 per set.
Vent System:
Axial (6-5/8" outer / 4" inner liner) rigid
fl ue and Riser Vent Terminal.
8
1) Provide adequate clearances for servicing,
proper operation and around the air openings
into the combustion chamber.
2) The appliance must be installed on a fl at,
solid, continuous surface (e.g. wood, metal,
concrete). This may be the fl oor, or it can be
raised up on a platform to enhance its visual
impact. The appliance may be installed on
carpeting, tile, wood fl ooring or other combus-
tible material, because the appliance's metal
pedestal base extends the full width and depth
of the appliance. The ULTIMATE Rear Vent
Direct Vent Freestanding Gas Stove can be
installed in a wide variety of ways and will fi t
nearly any room layout. It may be installed in
a recessed position, framed out into the room,
or across a corner.
3) The ULTIMATE Rear Vent Direct Vent Free-
standing Gas Stove is approved for manufac-
tured home installations, see "Clearances to
Combustible" to "Rigid Pipe Venting - Vertical
Terminations" section for the required vent ar-
rangements. If installed into a manufactured
home the unit must be bolted down to the
fl oor.
4) We recommend that you plan your installa-
tion on paper using exact measurements for
clearances and fl oor protection before actually
installing this appliance. Have a qualifi ed
building inspector review your plans before
installation.
U37-1 Regency
GENERAL SAFETY
INFORMATION
1) The appliance installation must conform with
local Canadian Electrical Code.
2) The appliance when installed, must be electri-
cally grounded in accordance with local codes,
or in the absence of local codes with the current
National Electrical Code, ANSI/NFPA 70 or CSA
C22.1 Canadian Electrical Code.
3) The appliance should be inspected for shipping
damage before use and serviced annually by
a professional service person. More frequent
cleaning may be required due to excessive
lint from carpeting, bedding material, etc. It
is imperative that control compartments, and
circulating air passageways of the appliance
be kept clean and free from excessive lint from
carpeting.
4) See general construction and assembly in-
structions. The appliance and vent should be
enclosed when installed in or passing through a
living area, where children may come in contact
with it.
5) This appliance must be connected to the speci-
fi ed vent and termination cap to the outside of
the building envelope. Never vent to another
room or inside a building. Make sure that the
vent is fi tted as per the instructions starting in
the "Venting" section.
6) Inspect the venting system annually for blockage
and any signs of deterioration.
7) Venting terminals shall not be recessed into a
wall or siding.
8) Any safety glass removed for servicing must
be replaced prior to operating the appliance.
9) To prevent injury, do not allow anyone who is
unfamiliar with the operation to use the fi replace.
Emissions from burning wood or gas could
contain chemicals known to the State of Cali-
fornia to cause cancer, birth defects or other
reproductive harm.
®
ULTIMATE Rear Vent Direct Vent Freestanding Gas Stove