Before Operations - JVC KW-NX7000 Instructions Manual

INTRODUCTION

Before operations

Map screen
Touch panel
In the explanation, operating buttons shown on the touch panel are indicated inside [ ].
For details on the touch panel operations, see each section.
Features of the illumination
Monitor panel buttons
The lights of the monitor panel buttons are turned off
when no operation is done for about 5 seconds.
They are turned on again in the following cases:
– When you touch the touch panel or move your hand
nearby*
– When you use the remote controller
– When a call/SMS comes in (for Bluetooth mobile
phone)
– When the source is automatically changed by
receiving the Traffic Announcement/PTY programme
* Depending on the <Illumination> setting.
(☞ page 111)
Monitor panel
AV screen
Touch panel
The lights of the monitor panel buttons are always
turned on in the following cases:
– While operating buttons are displayed on the
map screen.
– While AV menu screen is displayed.
– While <Source Menu> screen is displayed.
– While <Open/Tilt> menu is displayed.
– When <Illumination> is set to <Normal>.
(☞ page 111)
Screen
While the unit is turned on, you can turn off the screen
by holding DISP.
The screen is turned on again in the following cases:
– When you touch the touch panel
– When you press MAP on the monitor panel or press
DISP
– When a call/SMS comes in (for Bluetooth mobile
phone)
– When the signal from the rear view camera comes in
5
Monitor panel
[Hold]
INTRODUCTION