Regency Liberty L676-NG1 Owners & Installation Manual page 32

6) FOR L676-1 UNITS ONLY. L900-1 units proceed to step 7.
Remove the burner orifi ce cover plate from the log tray by undoing
the 2 screws.
7) Install the back brick panel by carefully placing it against the back
wall of the fi rebox as shown.
NOTE: L676-1 Back Brick Panel, top has 4 full brick patterns and the
bottom has 2 half bricks at each end. L900-1 is fi ne either way as
both top and bottom are the same. L900-1 back brick panel shown
in place below.
Back Brick Panel
8) Place the top brick panel into position and hold it in place while slid-
ing the right side brick panel into position and secure using the brick
panel clip that was removed in step 5 (see Diagram 12).
Top Brick Panel
Regency ® L676-1 Direct Vent Gas Fireplace
Burner Orifi ce Cover Plate
Diagram 8
Diagram 9
Diagram 10
9) Slide the left side brick panel into position and secure in place with
the 2nd brick panel clip that was removed in step 5.
Top Brick Panel
L900-1
Left Side
Brick Panel
Diagram 12
10) FOR L676-1 UNITS ONLY:
Re-install the burner orifi ce cover plate.
INSTALLATION
Right Side
Brick Panel
Diagram 11
L676-1 Brick Panel Clip
L900-1 Brick Panel Clip
Brick Panel Clip -
L676-1 only.
*Use this hole to
secure clip.
Back of
Front of
Unit
Unit
Diagram 13
Diagram 14
31